Tannoy CVS6

The CVS6 is supplied with an integral zinc-plated steel back can, with recessed termination box, the removable locking connector has screw terminals for secure wire termination and \\\\\\\\\\\\\\"loop through\\\\\\\\\\\\\\" facility. Strain relief is provided by a clamping mechanism for use with plenum rated cable or conduit.



An integral low insertion loss 60W line transformer uses an easily accessible front baffle mounted rotary tapping switch to select between low impedance and 70V or 100V operation:



70V: 60W / 30W / 15W / 7.5W / OFF & low impedance operation



100V: 60W / 30W / 15W / OFF & low impedance operation.



Security toggle clamps make for quick and easy installation, while two tile support rails and one C-ring are also included in the package. A plaster (mud) ring is available as an optional accessory.



PERFORMANCE

Frequency Response (-3dB) (1) 79Hz - 21kHz

Frequency Range (-10dB) (1) 60Hz - 24kHz

System Sensitivity (1W @1m) (2) 91dB (1W = 2.45V for 6 Ohms)

Nominal Coverage Angle 90 degrees conical

Coverage Angle (1kHz to 6kHz) 93 degrees conical

Directivity Factor (Q) 7.7 averaged 1kHz to 6kHz

Directivity Index (DI) 8 averaged 1kHz to 6kHz

Rated Maximum SPL Average:109dB

Peak: 115dB

Power Handling (3) Average: 60W

Programme: 120W

Peak: 240W

Recommended Amplifier Power 120W @ 6 Ohms

Nominal Impedance 6 Ohms

Transformer Taps (via front rotary switch) 70V: 60W / 30W / 15W / 7.5W / OFF & low impedance operation

100V: 60W / 30W / 15W / OFF & low impedance operation

Crossover 2.5kHz

TRANSDUCERS

Low Frequency 150mm (6.00\\\\\\") mineral loaded cone

High Frequency 19mm (0.75\\\\\\") coaxially mounted

PHYSICAL

Enclosure Back Can: Zinc plated steel

Baffle: Reflex loaded UL 94V-0 rated ABS

Grille: Steel, with weather resistant coating

Safety Features Safety ring located at rear of enclosure for load bearing safety bond

Clamping Design Security toggle clamp

Cable Entry Options Cable clamp & squeeze connector for conduit up to 22mm

Connectors Removable locking connector with screw terminals with \\\\\\"loop through\\\\\\" facility

Safety Agency Ratings (pending) UL-1480, UL-2043, CE

Hole Cutout Diameter 250mm (9.84\\\\\\")

Dimensions Bezel diameter: 279.5mm (11.01)

Front of ceiling to rear of back can: 246.5mm (9.70)

Front of ceiling to top of safety loop: 258.5mm (10.18)

Net Weight (ea) 4.75kg

Included Accessories C Ring

Tile bridge

Paint mask

Cutout template

Grille

Optional Accessories Plaster (mud) ring